s

PR250/0253/0250B ISS.6 / ABB PR250 Circuit Board

·        Overcoating interval for Epinamel PR250 cured with Epinamel EH100 Standard Part B when top coating with compatible two-pack epoxy and polyurethane coatings.

·        Mix Epinamel PR250 Part A with Epinamel EH100 Standard (Std) Part B or Epinamel EH120 Low Temperature (LT) Part B only.

·        Induction time – none.

·         Pot life at 25°C - 6 hours (Epinamel EH100). Do not use after this time even if the mix is still liquid.

·         Stir the components and mixed product well using a mechanical mixer.

·         The temperature of the mixed product must be above 15°C, otherwise extra thinner may be required to obtain application viscosity.

Request A Quote

PR250/0253/0250B ISS.6 / ABB PR250 Circuit Board

·        Overcoating interval for Epinamel PR250 cured with Epinamel EH100 Standard Part B when top coating with compatible two-pack epoxy and polyurethane coatings.

·        Mix Epinamel PR250 Part A with Epinamel EH100 Standard (Std) Part B or Epinamel EH120 Low Temperature (LT) Part B only.

·        Induction time – none.

·         Pot life at 25°C - 6 hours (Epinamel EH100). Do not use after this time even if the mix is still liquid.

·         Stir the components and mixed product well using a mechanical mixer.

·         The temperature of the mixed product must be above 15°C, otherwise extra thinner may be required to obtain application viscosity.

All Rights Reserved © SV Exim 2023 | Developed By Tozzu Technology