GE Fanuc IC693ALG221J Input Analog 4PT Current

IC693ALG221 is an Analog Current Input Module with four input channels for the Series 90-30 Programmable Logic Controller.

This controller’s channels are each capable of converting an analog input signal into a digital signal as needed for the application.

 Two input ranges are available with a default of 4 to 20 mA with scaled user data so 4 mA corresponds to a count of zero and 20 mA to 32000.

 Each 1000 count represents 0.5 mA. If a jumper is added to the I/O terminal board, the input range is adjusted to 0 to 20 mA with scaled user data scale corresponding to a count of 32000 with each 800 count equal to 0.5 mA.

This module is equipped with two range jumpers:  one for channels 1-2 and one for channels 3-4.

The IC693ALG221 input module allows conversion speed of one half milliseconds for each of the channels with an update rate of two milliseconds for any of the provided channels. Resolution speed on a converted signal is 12 bits over either chosen range.

 Percent AI user data registers in 16 bit 2’s complement format.

 If the current source is reversed into the input, the module will output a data word that parallels to the low end of the range.

Input protection for the IC693ALG221 is sufficient to work with reduced performance with up to 200 V in common mode settings.

This module also allows electrical isolation of external noise. All field connections require a good grade twisted, shielded instrumentation cable connected to the COM or GND. An LED indicator monitors power supply operation.

The main power source specific to the IC693ALG221 is +24 VDC supplied PLC power routed through an inverter for the module.

 IC693ALG221 uses power from the +5 VDC output to drive isolation circuitry. 

Input Current Ranges:- 4 to 20 mA and 0 to 20 mA

Calibration :- Factory calibrated to 4 µ A per count

Resolution at 4-20 mA :- 4 µ A (1 LSB = 4 µ A)

Resolution at 0-20 mA :- 5 µ A (1 LSB = 5 µ A)

Absolute Accuracy :- 0.1% full scale + 0.1 reading

Common Mode Voltage :- 200 Volts

Isolation :- 1500 volts between field side and logic side

Common Mode Rejection :- > 70 db at DC; >70 db at 60 Hz

Cross-Channel Rejection :- > 80 db from DC to 1 kHz

Input Impedance :- 250 ohms

Input Filter Response :- 325 Hz

Internal Power Consumption :- 100 mA from the isolated +24 volt supply 25 mA from+5 volt bus on the backplane